Bill, I don't know exactly what you are looking for, but I picked up a dinette table that is parquet that I most likely will not use. Not sure if that could help?
Search found 117 matches
- Wed Jul 04, 2018 7:52 am
- Forum: Drivetrain
- Topic: Water out of spark plugs hole.
- Replies: 10
- Views: 712
I had one of these engines before. "Ran great before it sat for 6 years" One issue I ran into that I did not think of at the time, was the lifters were stuck, not in the holes, but the hydraulic little pistons inside of them were stuck. Sometimes you can work them free, but I took them to ...
- Mon Jul 02, 2018 8:55 pm
- Forum: Electrical and Electronics
- Topic: Starting challenges
- Replies: 4
- Views: 426
Well, figured it out. 45 years was enough for the wire that goes from the "I" on the ignition switch to the "S" on the starter. After replacing the starter, ignition switch, battery cables, moving the ground 100 times, I finally ran a new wire from the ignition switch on the brid...
so switching from Chryslers to Chevy's. I have a starter that has a positive post, and "R" and a "S". Ignition system is Mallory Unilite. Coming from Ignition switch on helm is a purple, a white, and a red. Think red goes to positive post along with battery cable. That's where I ...
So moving to a larger prop and shaft and it seems the prop is aweful close to the rudder, maybe an inch? Is there a minimum distance that is preferred. Could not have been too much more than that with the old set up.
I would paint, but high degree paint not necessary. Paint on the bottom where it bolts to head will burn off no matter what you use - the rest does not get that hot. I always use a sealant with the gaskets to fill in all the nooks and crannies - others may not. Just re-read your email. If your talki...
- Mon May 07, 2018 6:43 am
- Forum: About My Boat Brags
- Topic: "Easy Does It" joins "Aquaholic" in the Lambert M fleet
- Replies: 4
- Views: 1271
Congrats! Baffled by you guys that can take on 2 boats. 2 things come to mind, time and money.
Now that the rudders are done - Yes - that is an obvious and excellent suggestion. That did not cross my mind!! Bottom line is, I was going to have to have some work done to the shafts as the crusaders with reduction gear add about 6 inches to the drive train. I would have had to cut them down anywa...