Marinette Boat Forum

Does anyone know how to repair a cut Capac cable, the cut is about 12 inch from the Capac sensor in the bilge.
Any help is much appreciated.
John

I have to make a extra intake hole for a 3/4 inch seacock to supply water for a new toilet.
what is the best way to make a hole in the hull and to install the seacock, what is the best & easiest to buy.
John

The problem is, I have a cut Capac cable about 12 inches away from the sensor in the bilge,
how can l repair this? can this be done.
John

Happy Thanksgiving to you all, You couldn't have said it better Jeff.
John

Hello fellow Marinette owners, I'm planning to install a Jabsco electric toilet, Can I install a raw water manifold right after the seacock for the engine, for toilet water supply. Or is there a better way of doing.
All help is greatly appreciated.

John

here are some images

thank you
John

Good Day... Here are some images of the work we did to get access to the water pump and making a access hatch to it through the aft deck. I have also added a image the damaged impeller that we replaced.

Mission completed !! To get access to the pump we had to cut and remove a small section of the aft deck. Between the engine hatch and bulkhead, by doing this we could reach the pulley and pump. To remove the section of 1/2" took 1 hour. To remove and reinstall the pump another 2 hours. the tota...

Good day Folks, Is there any way for me to post images on to the forum along with my questions?

John

Bill and Jeff thanks for the reply. The local marine mechanic turned me down ( can't get ad it attitude) Tomorrow I will mark the aft deck starboard corner what we able to cut out including the bulkhead. Saturday an other mechanic will have a good look at, which way to proceed , at that time I will ...