Search found 6 matches

by levelwind
Mon Jan 15, 2018 4:17 pm
Forum: Boat and Hull
Topic: There is a Marinette missing a Flybridge.
Replies: 4
Views: 133

Re: There is a Marinette missing a Flybridge.

It looks like it might be from a 28'
by levelwind
Sun Jan 07, 2018 10:27 am
Forum: Electrical and Electronics
Topic: Running light bulbs
Replies: 10
Views: 471

Re: Running light bulbs

We replaced the anchor and all interior dome lights with LEDs for power savings. Both were purchased on eBay in lots of 10 for less than the cost of one at any retail store. A little resea
by levelwind
Thu Sep 14, 2017 3:17 pm
Forum: Engines
Topic: exhaust manifold
Replies: 5
Views: 366

Re: exhaust manifold

Go2marine.com or marinepartssource.com. I purchased manifolds from one or the other and even returned the brass tubes for full credit hassle free because the instructions said not use them for my configuration.
by levelwind
Fri Jun 02, 2017 5:55 am
Forum: Engines
Topic: Proper Carb Size for 318
Replies: 16
Views: 851

Re: Proper Carb Size for 318

Not sure. That's why I'm inquiring. I am the 4th owner. The 3rd didn't replace them and he bought the in central OH. Going through some old receipts there seemed to be a lot of overpriced repairs done that I would have questioned. When I found an exact Carter rebuilt replacement on EBay, I contacted...
by levelwind
Thu Jun 01, 2017 12:13 pm
Forum: Engines
Topic: Proper Carb Size for 318
Replies: 16
Views: 851

Proper Carb Size for 318

My 318's have Carter AFB 750 CFM carbs. I was told this by the number and the primaries are almost as big as the secondaries. I rebuilt the starboard and the port kit is on order. Considered upgrading to Edlebrock but which one 1409 is 650 CFM or 1410 is 700 CFM. Will I gain or lose fuel economy goi...
by levelwind
Mon Sep 14, 2015 5:49 pm
Forum: About My Boat Brags
Topic: Waste Pump out Cap
Replies: 2
Views: 833

Waste Pump out Cap

Hello I am having trouble finding a replacement cap for our Jabsco waste pump out. It is the large fitting. The outside cap diameter is 2 1/8" and the thread is 1 7/8". I searched online and all seem to be too small. Any suggestions. Here's some pics. 2IMG_.JPG 1IMG_.JPG 3IMG_.JPG Thanks

Go to advanced search