Marinette Boat Forum

NP Wayne, glad it helped, beautiful weather here today, any excuse to go to the boat!

They do. Here's mine on the starboard motor...

Wayne, It's was kind of tough getting a picture but here's a couple of the port motor pump. The drain screws are facing to the port side, same for the offset port inlets and outlets. First pic is looking at the motor from the port side and the other is looking down at the pump... If I got the wrong ...

Hey Wayne
I've got the same boat so if you don't get an answer I'll take a pic of my pumps mounted, Sherwood D60's.
Rob

Interlux 2000 E is primer. Therefore you do not primer bare aluminum with self etching primer first? From their P sheet it looks like you have to prep the aluminum per their instructions and use thinned coats of the I 2000 epoxy primer right on the bare aluminum. Does not say you need to use etching...

Always drooled over Checkmates growing up. Real nice job, turned out nice.

I added a gallon of "Seafoam" when I filled up 2 yrs ago. About 80 gallons. Says it stabilizes gas for 3 yrs. Boat was winterized and sat idle till this year. Both motors fired up and run fine. They're die hard 318's.

That is cool! That tow truck's classic too! Thanks for the link.

Might check the cable linkage back at the tranny. Mine slipped out of the bracket (was hard to notice) but I lost reverse.

Isn't that the way it suppose to work? Mine pukes out every 10 sec or so just like yours.