Search found 75 matches
The only thing I can think of there was a bit of debris in the needle valve seat holding it open, don't know just speculation on my part. And yes did check the oil multiple times for contamination, sure some got in but doesn't appear to be much.
Well I can finally report engines are running great, new carb was installed and electrical problem fixed. Can only speculate that was something stuck under one of the needle valves, don't really know though. Going forward with a new filtration system, it is my intent to double filter the fuel, first...
- Thu Jul 20, 2017 6:45 am
- Forum: Boat and Hull
- Topic: transom gate and swim platform
- Replies: 24
- Views: 753
Piedmont Plastics quoted me $980.00 for for a solid piece of 1"x4'x12', Starboard-textured, and somewhere in the $300.00 range for CNC Routing. Would have to modify my current supports if not replace, wheels are turning. Have you filled the openings in the transom?
- Wed Jul 19, 2017 1:38 pm
- Forum: For Sale or Wanted
- Topic: Wanted 28" Sportsman
- Replies: 13
- Views: 570
Please post the pictures, interested. Had previously spoke with Piedmont Plastics about cutting a swim platform out of a solid piece of Starboard. They said no problem cutting but getting a piece any longer than 96" would be special order, not to mention expensive. Was also concerned about it l...
With you on that one, yes fuel lines are new along with the filters, checked everything for restrictions all the way back to the tank fittings, nothing. Updating my post from July 6th I did switch the carbs port to starboard, starboard to port and the starboard engine displayed the same symptoms. Wi...
As of this writing the carb has been swap out with a new one but is yet untested, electrical problem with the same engine-port. Speculation from both Edlebrock and Jeggs is there is some manufacturing debris under the needle valves causing some restriction as well as a fuel dump, sounds good. Might ...
That would be my luck. Was thinking, just to confirm it is the carb I would switch the carbs, port to starboard and vice verse. Same amount of bolts-screws to loosen and tighten, just hate the thought of breaking the seal on a new carb.
Gauges are located between the inline filter and the carb inlet, filter's are new, Wix. After switching the fuel lines to opposite engines, running the port engine off the starboard fuel pump and the starboard off the port, and the port engine still stalling I'm of the belief it has to be the carb. ...