Marinette Boat Forum

Buck Algonquin

Ok thanks... A picture of a setup would be helpful..

When I installed the test Pertronix units in 2012 we used the collar that was used on the OEM Prestolite on STB engine. No issues.

I had heard there was an early issue with the collar supplied with new units from Pertronix but it was corrected. Must have got one that was early.

I have been field testing a Pertronix Dist. with their ignition. I am now on season 7 and am not looking back.
Been flawless and my M is in the water 24/7

I have ran a Xantrex 1800 watt inverter for years on my boat. I run 2 deep cycle 6 volt golf cart batteries in series. Inverter works fine for light loads. Using heavy amp like microwave etc. and it will draw your house bank down in very short order. 1500 watts will draw 125 amps DC. So lets say you...

It has been a long time since I have been on the forum. Health issues pretty much limited my boating last season. Back up and going strong! Anyway time for spring commissioning. My Raritan OEM Hot Water heater finally rusted out. Gee only 31 years of service! I would like to replace it with a heater...

10 K for new one

Senior moment where are the neutral switches located

Very nice !

Ideal range:
.95-1.05

numbers will vary depending on water clarity and wether fresh or salt water.

safe boating,
Dave