Marinette Boat Forum

Quite a boat!! Hope you're able to sell for at/close to asking price. It's worth it!

Question (as I already have a 32' and next (dreamer) purchase would be a 41' Marquis)... where did you find/buy the end table/drawer(s) unit in the salon between the white/aluminum deck chairs?

Thx,
Bill

We used a Xantrex 1000W inverter. http://www.ase-supply.com/Xantrex_806_1010_PRO_Series_Inverter_p/xa-806-1010.htm It supplies plenty of affordable AC to the fridge (ours draws 74 watts when running). You'd need to check your fridge's current draw + normal run time as it cycles on/off to figure the ...

With MetalHead's notation above, you can use this as sort of a "message has been read" alert, similar to AOL's system for emails sent to other AOL members. A backdoor "email receipt".

Bill

I'd rather think of you, Jeff, as the "Epitome of Frugality"!!


Bill

I'm concerned....

... flippin' the rotor so many times could cause cramping...

... best to stop every few " flips " snd re-exercise the fingers/hand...

... grabbing a brewski should work quite well!!!


And in doing so should keep the "flipper" well oiled as well.

Bill

:| Hope I get better results with the Micron CF. Painting the bottom with a coat of white and then a coat of black. Boat's on blocks and won't go into water (Ohio River) till next spring. Will "back pocket" the info on Sea Hawk bottom paint when she's next pulled from water in fall 2018 an...

I can measure length when I'm next at boat, or if someone else can...?
Only wrinkle will be at upper end's end.
Bill

Busia, (If you're still alive... :-D ), great story!! I use a plastic ammo box attached to the entrance to the chain/rode locker. I only use 15' of chain attached to my rode which seems to be sufficient to keep the anchor on the bottom and set well. Cutting a hole on each long side of the box allows...

We use Geico Marine Insurance (used to be Seaworthy). Good rates.
https://login.seaworthyinsurance.com/SI ... Login.aspx

Bill

Jeboniface,

Thanks for posting the pics. Nice work and great detail. Did you need to special order the aluminum channel across the top of the gate?

Bill