Marinette Boat Forum

I had all sorts of ideas as I have witnessed repairs to hydrocarbon processing units and even seen machined parts. The Belzona folks talked me into pouring in 5831 to a thickness of about an inch. I am in awe of the strength. I have never seen anything like it. Built in galvanic corrosion protection...

Sorry- vendor is Outwater Plastics Industries Inc. On website look at the catalogue on page 207 and you will see aluminum extrusions and 1 1/2 inch tubing connectors.

Hey that's great I bought one as well when I purchased the zincs. I got the vendor from this site. I have high hopes.

Hey I am in the same situation. looks like I am going to have build. I worked on the old doors but there is just too much work to restore them. So far extruded aluminum box tube with 1/2 starboard/glass on top. I think with tube fittings we can make up nice doors. The question is to slide or fix and...

Yes sir it was sandblasted. In that case it should be connected to the galvanic isolator right?

I am just now reinstalling exhausts, tanks, generator and am trying to zero in on wiring. This weekend I will chase down the one wire that was attached to the top. I want to say it has to be part of a Capac but maybe it is some kind of transducer.

Following up after repairing the pitting and painting

I wanted to share the final product. This is the starboard shaft log. I had extensive damage on the port side and welded thin plate over it. Bill said use a $h1tload of JB weld and I decided to do just that as well. For good measure I pored about a 1/2 inch on the starboard side as PO had obviously ...

Here is a picture

Guys I found a round, about 1 and a half inch diameter, thru hull that is constructed of bronze covered with a copper cap. It has DO NOT PAINT on it (it was painted) and a spot for a wire to connect on top (inside). What is it?