Page 5 of 5

Re: Aft Deck Restoration

Posted: Thu Apr 13, 2017 12:51 pm
by DougDoty
I am 260 lb and do not think my original 5/8" decking feels at all springy. I have replaced the hatch and the section forward of it thus far. My hatch had gotten rotten and the section in front of it was beginning to sag in the middle over time and held water. in a pool. I need to do the three remaining sections still, they are not soft anywhere but have holes from mounted fishing chairs and down riggers.

Re: Aft Deck Restoration

Posted: Tue Sep 05, 2017 1:17 pm
by Joe
Hello, I will be starting this winter on replacing the aft deck. Do you have any finished pics. I would like to see some different finished pic. Thanks Joe

Re: Aft Deck Restoration

Posted: Wed Sep 06, 2017 4:21 am
by MetalHead

Re: Aft Deck Restoration

Posted: Tue Sep 12, 2017 4:54 pm
by yooper
Cut new plywood decking from 5/8" exterior plywood. Had a pickup bed sprayer spray and underlap the bottom side by 6". Replaced the big washer on the cockpit drains with a big 1/4" aluminium flage that fits under the corner side walls. Tighten the cockpit drain nut and the deck is tightened down in the corners. Only put back the under deck screws I could reach.

Re: Aft Deck Restoration

Posted: Sun Oct 22, 2017 5:16 pm
by Joe
Hello trying to decide on what to use, on the aft deck . Has anyone used NAUTIFLOOR ? I was looking at the 65TE . I looked at plastek. I did not like the way it was glued together. I seen a swim platform with it. It did not hold up very well. I was going to go with starboard ,Butt the wife likes the look of the teak. Thanks Joe

Re: Aft Deck Restoration

Posted: Sun Oct 22, 2017 11:36 pm
by jralbert
My plasteak bowsprit held up for years with no maintenance and always looked like new (was still going strong when I sold it). With more energy for a project, I would have covered rear deck with it. Mine was T&G (tongue and groove) - no glue. For the rear deck I would have used some kind of mfr-approved sealant in the groove where two pieces lock together.