318 Oil Pressure sender line

Engines, Shafts, Steering, Struts, Rudders, etc.
Aluminum Star
Posts: 167
Joined: Mon Jul 14, 2014 11:21 am
Location: Cumming, GA

318 Oil Pressure sender line

Postby ericinga » Sun Jul 20, 2014 3:13 pm

The small hose routed from the block to the oil pressure sender has been leaking. It's the small hydraulic hose with a metal spring cover. Temporarily, I replaced it with a length of fuel hose and clamps. Oil pressure is only 30 pounds so this should hold for now.

Should be replaced with a similar style hose with hydraulic fittings?

Eric Spies
1989 32 SDFB
Twin 318s
Lake Lanier, GA
Marinette Boat

Site Admin
Posts: 891
Joined: Sat Jul 12, 2014 5:06 am
Location: Rock Halll, MD

Re: 318 Oil Pressure sender line

Postby Fastjeff » Tue Jul 22, 2014 5:25 am

Yes. You need a hydraulic hose. Any one you buy will be strong enough.

Only 30 pounds pressure? I'd check that with a hand held gage screwed into the idiot light switch location. If it's true, I'd go to a heavier viscosity oil and some Lucas oil stabilizer.

"We live at the bottom of an ocean of air, not at the top." General Marvage Slatington

New poster
Posts: 9
Joined: Tue Jul 15, 2014 2:20 pm

Re: 318 Oil Pressure sender line

Postby pfhlaw » Wed Jul 23, 2014 11:01 pm

The metal fittings are male 1/8" NPT on each end of the hose.
You could try replacing it with a grease gun hose. It's got the same size fittings and is made to handle petroleum products at high pressure.
They're about $5.
1981 32' sedan bridge
New Buffalo, MI