I believe that a re-prop is going to be in my future.
Just wanting to check on the correct shaft size for our 32 Sedan FB with twin Chrysler 360's.
I believe they should be 0-1 1/4" but would like some input because I might have a chance to get props before I can pull the boat and install them.
Shaft size for 360's?
-
- Aluminum Star
- Posts: 163
- Joined: Thu Sep 11, 2014 7:27 pm
- Location: Southern Indiana / Louisville
Shaft size for 360's?
1984 32' Sedan FB
Twin Chrysler 360's
1.52:1 Velvet Drives
Raw water cooled
Ohio River
Twin Chrysler 360's
1.52:1 Velvet Drives
Raw water cooled
Ohio River
Re: Shaft size for 360's?
1 1/4" on our 1986, 32 Sedan with 360s & 1.5 reduction.
Also had 1 1/4" shafts on our 1989, 28 Fisherman with 318's & straight drive.
I believe the earlier years had 1" shafts. At some point Marinette changed all to 1 1/4".
-karl
Also had 1 1/4" shafts on our 1989, 28 Fisherman with 318's & straight drive.
I believe the earlier years had 1" shafts. At some point Marinette changed all to 1 1/4".
-karl
1986 Sedan 32'. Twin Chrysler 360in^3, 275hp.
Forum member since 1998.
Forum member since 1998.
Re: Shaft size for 360's?
They used 1 inch for 1:1 drives and 1 1/4 inch for 1.52:1 drives.
Jeff
Jeff
"We live at the bottom of an ocean of air, not at the top." General Marvage Slatington