Marinette Boat Forum

Warning! If that distributor is going in a reverse rotating motor, it needs special thrust bearings to withstand the upward force that is developed.

We've been down this road with a few aftermarket distributor techs by now, so they SHOULD know what we want.

Jeff

Is the thrust bearing on the seat or inside the shaft?

My engine turns counter and I heard these were good ones:

Pertronix D241801 Flame-Thrower Plug and Play Red Cap Marine Billet Electronic Distributor with Ignitor II Technology with Red Cap for Chrysler 273-360

I think I need the spacer machined, if my memory serves me right.