Page 1 of 1
Ceramic starter item
Posted: Sat May 12, 2018 7:13 pm
by GregM
Can someone tell me what this is. It crumbled when I tried to remove it. I am not sure what to ask for at the local part store or if it is marine specific? Its for a 318 Chrysler motor I am rebuilding and is part of the starter circuit. Any advise on where to get a replacement would also be helpful?
Re: Ceramic starter item
Posted: Sat May 12, 2018 8:08 pm
by EWRice
That is your ignition ballast resistor. You must have electronic ignition. Sierra p/n 18-5451
I think the automotive ones are the same.
Re: Ceramic starter item
Posted: Sat May 12, 2018 8:16 pm
by GregM
Thank you man! I can't afford any more marine costs! Your a life savor!
Re: Ceramic starter item
Posted: Sat May 12, 2018 10:04 pm
by javalin390
Hold on there !! You MUST use the marine specific ballast. The automotive version is not sealed and thus will cause an engine room fire. I think NAPA carries both auto and boat ballasts for close to the same price, but you MUST use the marine version.
Re: Ceramic starter item
Posted: Sun May 13, 2018 7:12 am
by GregM
Stick with marine! Got it, thank you for pointing that out! No fire hazard is worth saving a few bucks.
Re: Ceramic starter item
Posted: Mon May 14, 2018 5:51 am
by hightension
Amazon carries them also. Just order 2 of them
Re: Ceramic starter item
Posted: Mon May 14, 2018 10:47 am
by bill
Definitely carry a spare and make sure it is a Marine ballast resistor. The back will be filled with ceramic or epoxy.
There is no way of knowing when it will burn out. Usually at the worst possible time.
Welcome to the world of Marinette..
bill
ps When you get a chance please add a signature to your posts.