Rivnut tool

User avatar
bcassedy
Royal Aluminum Star
Posts: 360
Joined: Sun Jul 13, 2014 10:05 am
Location: Aurora, In.
Contact:

Rivnut tool

Postby bcassedy » Mon Jul 29, 2019 1:01 pm

Years ago, FastJeff detailed how he had replaced the stantion bases on his boat. He used a method for setting the rivnuts into the hull which worked. I recently found that (gag, choke...) Harbor Freight sells a rivnut setting tool with rivnuts for 22.99. ( https://www.harborfreight.com/45-piece- ... XGEALw_wcB ) HOWEVER, the rivnuts included with the tool are smooth sided which means installing them would fall to the serrations under the flange of the rivnut AND the tightness of the set to keep the nut from turning as your tightening a bolt/machine screw into it.

It's far better to use a rivnut with serrated sides, as well as the underside of the flange (in conjunction with a tight placement of the rivnut). One place to buy these type rivnuts is Randall Nutset ( https://www.heritageparts.com/Manufactu ... lsrc=aw.ds

Using these two products should make remounting a stantion (or any situation where you need a threaded backing) a lot easier.

Bill
Bill & Sharon Cassedy
"Sunset Seeker"
'88 32' Sedan Bridge
Located in Aurora, In.
Twin 318cu in Chrysler
1.5:1 Velvet drive trannies
Fresh water only

Fastjeff
Site Admin
Posts: 1155
Joined: Sat Jul 12, 2014 5:06 am
Location: Rock Halll, MD
Contact:

Re: Rivnut tool

Postby Fastjeff » Tue Jul 30, 2019 7:05 am

Good call! Hard enough to get those little buggers nice and tight. The rivet nut installation works super, however, for my railing remained tight for over a decade.

Jeff
"We live at the bottom of an ocean of air, not at the top." General Marvage Slatington