Coupler Alignment - Vibration

Engines, Shafts, Steering, Struts, Rudders, etc.
Fastjeff
Site Admin
Posts: 1522
Joined: Sat Jul 12, 2014 5:06 am
Location: Rock Halll, MD

Re: Coupler Alignment - Vibration

Post by Fastjeff »

Smart move. Anone can make a mistake, but serving their customer is priceless.

Jeff
"We live at the bottom of an ocean of air, not at the top." General Marvage Slatington
jralbert
Site Admin
Posts: 885
Joined: Fri Jul 11, 2014 9:15 pm

Re: Coupler Alignment - Vibration

Post by jralbert »

IT sounds as if you are putting this matter behind you, moving on. But your discussion with the marina operator should serve to put them on notice that in the future, more care should be exercised to see that the straps are properly placed. It's simple, good protocol in marina lifts. One thing you might want to consider: mark the spot where straps should be placed with permanent tape or paint and when it's time to lift, remind the marina about those locations. You can have more damage than to just the shafts when a boat in improperly lifted. Good luck
-joel-
former owner 1988 '32 FB Sedan
Chesapeake Bay
twin 318 / 240 hp
Potomac MD
SolomonsDrake
Tin star
Posts: 21
Joined: Mon Jun 14, 2021 10:36 pm

Re: Coupler Alignment - Vibration

Post by SolomonsDrake »

Agreed, Joel! I was explicit that I expect them to be more careful going forward, and talked about where the straps need to be placed. I will be reminding them the next time we pull it out.

Tim
Voyager
1977 32' Sedan Flybridge
Twin Chrysler 318s
Chesapeake Bay
Fastjeff
Site Admin
Posts: 1522
Joined: Sat Jul 12, 2014 5:06 am
Location: Rock Halll, MD

Re: Coupler Alignment - Vibration

Post by Fastjeff »

You could add a nice big "S" to where the straps should go.

Jeff
"We live at the bottom of an ocean of air, not at the top." General Marvage Slatington
User avatar
bcassedy
Royal Aluminum Star
Posts: 508
Joined: Sun Jul 13, 2014 10:05 am
Location: Aurora, In.

Re: Coupler Alignment - Vibration

Post by bcassedy »

If you used Jeff's suggestion (recommended), you can get a pro look by getting a sheet or 2 of large vinyl (waterproof and a good look) letters at Office Depot or Staples.

Bill
Bill & Sharon Cassedy
"Sunset Seeker"
'88 32' Sedan Bridge to be sold (updtd 1-1-22)
"Sunset Seeker Too" (SS2)
'88 41' Marquis hardtop. (as of 1/1/22)
Located in Aurora, In.
Always fresh water.
Post Reply