Page 1 of 1
Replacing Breaker in 120 Volt Panel!!!!
Posted: Sun Feb 19, 2023 5:38 pm
by Jeepmanking
I made a YouTube video of me replacing breaker in the 120 volt panel with aftermarket marine/RV breaker. Hope this helps someone with their Marinette.
1987 Marinette 32 FB
#Fitforakingboatadventures
https://youtu.be/BYHZ0mr5BRU
Like and Subscribe to my YouTube channel many Marinette videos coming!!
Aaron King
Re: Replacing Breaker in 120 Volt Panel!!!!
Posted: Sun Feb 19, 2023 8:13 pm
by barefoot99
Why didn't you use an original style breaker?
Airpax breakers seem to work well.
Re: Replacing Breaker in 120 Volt Panel!!!!
Posted: Sun Feb 19, 2023 9:41 pm
by GB49
While you are in there check for hardened/slightly melted spade connectors. I have replaced several over the years that got a little warm for a bit too long. Generally the water heater, AC, refer etc.
Seems like electrical was not a factory specialty back in the 70s/80s.
Re: Replacing Breaker in 120 Volt Panel!!!!
Posted: Mon Feb 20, 2023 2:00 pm
by jralbert
GB49 wrote: ↑Sun Feb 19, 2023 9:41 pmSeems like electrical was not a factory specialty back in the 70s/80s.
Electrical shortcomings long have been documented. A flaw in otherwise outstanding boat. One area wired dangerously was/is the ungrounded circuit feeding the valance lighting on the sides of the cabin.
Re: Replacing Breaker in 120 Volt Panel!!!!
Posted: Mon Feb 20, 2023 4:20 pm
by Jeepmanking
If you look closer during the video you will see lower on the panel the same style of breakers that I installed. Sometime in the last 35 years some breakers were replaced to this bolt in style. I am making at least one side of panel look the same, a little OCD, I guess. Lol.