Page 2 of 2
Re: capac sensor
Posted: Tue Apr 19, 2016 11:28 am
by jralbert
Maestro wrote: the outer silver chloride surface is very dirty. I have been advised not to scrub at it. Basically keeping my fingers crossed that it stays working. I have checked it with a multimeter and it does read correctly despite the grime.
A soft (non abrasive) sponge with some dish soap should do the trick.
Re: capac sensor
Posted: Mon May 09, 2016 10:25 pm
by tjcimba
The cost directly from Siemens was less expensive than through the Florida vendor. I replaced both the thru hull sensor and the gauge. cost then was $360.
Re: capac sensor
Posted: Sun Mar 28, 2021 5:58 pm
by robalo220
Anyone have a line on a thru hull sensor replacement for Capac? There’s a guy on FB looking.
Thanks
Re: capac sensor
Posted: Mon Mar 29, 2021 7:14 pm
by robalo220
Never mind. The guy I was trying to help found a source