Page 1 of 2
Wind Screen for flybridge
Posted: Mon Jul 28, 2014 5:19 am
by 75Express
Looking for the correct thickness, material type, length and width of the front and two sides.
My bought is missing it so i have nothing to compare
Thanks
Re: Wind Screen for flybridge
Posted: Mon Jul 28, 2014 6:30 am
by Fastjeff
Mine was smoked plastic about 1/4 " thick.
Jeff
Re: Wind Screen for flybridge
Posted: Mon Jul 28, 2014 3:29 pm
by bill
75Express wrote:Looking for the correct thickness, material type, length and width of the front and two sides.
My bought is missing it so i have nothing to compare
Thanks
It depends on the size of your boat.
28'
32'
37'
39'
41'
That is why we use signatures
See mine below
Bill
Re: Wind Screen for flybridge
Posted: Thu Jul 31, 2014 6:14 am
by 75Express
Dang I guess I lost my signature with the new site
It is a 32 foot
Re: Wind Screen for flybridge
Posted: Thu Jul 31, 2014 6:59 pm
by 75Express
Thanks Fast Jeff
Re: Wind Screen for flybridge
Posted: Fri Aug 08, 2014 4:57 am
by 75Express
Can anyone tell me how wide the plexiglass is? 6 inches?,7inches? 8"inches?
Thanks
Stan
Re: Wind Screen for flybridge
Posted: Fri Aug 08, 2014 2:30 pm
by Joe
I have a set. Their off my 1988 32 .Their in my storage container. I could make a paper copy and send to you. I dont know if the later ones are the same. They are 1/4 inch. You need to use the right material . Or they will break. I made 3 set . The first 2 sets broke. Before you start. Take some of the plastic ,put it in a vice. and bend it over. If it breaks dont try to use it. If it bends ,and flexes back your good. . You will have approx 300.00 in material plus labor. Let me know Joe.
Re: Wind Screen for flybridge
Posted: Wed Aug 13, 2014 9:20 pm
by 75Express
Thanks for the offer Joe. I would love to have a pattern to work from. If it is not to much trouble.
Stan
Re: Wind Screen for flybridge
Posted: Thu Aug 14, 2014 5:35 am
by Fastjeff
Whatever you do, DON'T use Plexiglass; Lexan is a far better material--it's not so damn brittle!
Jeff
Re: Wind Screen for flybridge
Posted: Fri Aug 15, 2014 5:47 am
by Joe
Send me your address .
knockwafel@twc.com I will send it to you. Joe