rudder linkage?
rudder linkage?
Anyone know where I can get this?
1973 Marinette Seacrest Executive
41x14
Twin Chrysler 340's with Velvet Drive 71C
"Figment"
41x14
Twin Chrysler 340's with Velvet Drive 71C
"Figment"
Re: rudder linkage?
Ebay has a wide selection.
Inboard rudder tiller.
http://www.ebay.com/itm/Stainless-Steel ... 1293877222
or new
http://www.deepblueyachtsupply.com/stee ... iller-arms
bill
Last edited by bill on Sun Mar 22, 2015 1:27 pm, edited 1 time in total.
Former owner of
ALUMINATION
Grosse Ile MI
Located on LakeErie
37' F/B Sedan
1975
Twin 360 Chrysler Marine
Raw water cooled
Hydraulic steering both helms
USCG Master Lic. Retired[/color]
Third Owner bill
ALUMINATION
Grosse Ile MI
Located on LakeErie
37' F/B Sedan
1975
Twin 360 Chrysler Marine
Raw water cooled
Hydraulic steering both helms
USCG Master Lic. Retired[/color]
Third Owner bill
Re: rudder linkage?
That one on e-bay looks like it would work if the length is the same. ( it looks like brass, not stainless ) otherwise find one used from a scrapped boat or make one from a piece of stainless bar. To make one would be the fastest if you need it now. The old one could be brazed and machined to repair it, but might be cheaper to make a new one.--Ed
BUSIA
located in Ketchikan, Alaska. Gods country
32 foot Marinette (no fly bridge)
twin 350 Crusader (Chev 350) engines
1:1 Borg Warner velvet drive transmissions
Closed cooling (antifreeze in the engine)
Proud to be retired IBEW and an A+P
located in Ketchikan, Alaska. Gods country
32 foot Marinette (no fly bridge)
twin 350 Crusader (Chev 350) engines
1:1 Borg Warner velvet drive transmissions
Closed cooling (antifreeze in the engine)
Proud to be retired IBEW and an A+P